|
Description |
DSC-Series: HX50(V), HX60(V), HX90(V), HX300(V), HX400(V), RX10, RX100II, RX100III, QX30
ILCE-Series: A7, A7R, A77, A3000, A3500, A5000, A5100, A6000, NEX-3N, QX1 etc
SLT-Series: A58
HDR-Series: CX220E/B, CX230E, CX240, CX280E, CX290E, CX380E, CX430V, PJ230, PJ240, PJ380, PJ430, PJ530, PJ620, PJ790, PJ810, GW66, etc
DEV-Series: DEV-50
FDR-Series: AX100 4K
PXW-Series: PXW-X70
HDR-AZ1* Contact us if you need remote control
Note: QX10/100 cameras aren't remote controllable through Multiterminal interface.
CR-Camera 5/10-pin Multiterminal Interface Cable for Sony cameras/camcorders (length 32cm/11" - 7g). There are 2 options: cable with direct plug (occupies space beside of camera about 30mm) and with 90-degree plug (occupies space beside of camera about 10mm). Controls zoom (mostly 2 speed option), movie recording, auto focus* and shutter release* features of the camera. Be sure your camera have Multiterminal jack! Connect it to USB-LANC/RP port of the CAMremote. See example configuration. Note cameras with Multiterminal interface doesn't offer composite video signal (except camcorders). For Sony camcorders consider option below. Read more about limitations of MULTI/LANC interface from here.
* AF and Shutter release functions are not available if CAMremote is connected to PCSon |
CR-Camera 8-pin USB+AV Cable for Panasonic cameras (length 30cm/9.8" - 7g). USB have 8-pin connector, A/V connection has 3.5mm jack. USB is used to control Shutter release, Aperture, Shutter speed and ISO on GH4 only. Note: Panasonic GH4 is not supporting Movie recording and Zoom control through USB connection. Workaround is to use USB cable together with Remote Port cable.
A/V jack is used to connect composite video signal to video downlink equipment. A/V connection at male-plug pins: SLEEVE=Signal Ground, CENTER=Video, TIP=Audio.
Pls note: GH2-GH4 cancels composite video during movie recording (HDMI is available in any modes). All other modes composite video can be activated by holding down 'Trash' button about 5 sec. |
